To connect your mount to your computer via a router, you need to change the setup on your mount and your computer.
Once your mount is powered and computer and mount are connected to the router, on the hand controller of the mount:
1. Select Menu > Setting > Network > Configuration Network > Set IP Address
2. Enter the following data:
a. IP address 192.168.001.099
b. Network mask 255.255.255.000
c. Gateway 192.168.001.001
3. On your Windows computer, you can test the connection by press “windows key” + “R” on the same time on the keyboard. And run cmd and click on “OK”.
Then you can test the connection to the mount typing command line: “ping 192.168.1.99” and press “Enter” on the keyboard.
The above outcome shows a good connection. If you get the following result, then you need to follow the instructions (1. 2. 3.) on the last page to change the setup on the computer.
4. To check the connection and use the hand pad on your computer, install the program 10Micron Keypad:
a. Click on connection
b. Select LAN (TCP/IP)
c. Enter the IP address 192.168.001.099
5. Once you have installed the 10Micron Ascom driver, in communication enter the IP address 192.168.1.99
